BFT BOTTICELLI BT A1250 Garage Door Opener in Oman
The BFT BOTTICELLI BT A1250 is a 24V sectional garage door opener. It has a VENERE BT A DIS display control unit and D-Track force management. It suits doors up to 16 square metres and 120 kg traction force. We stock the BFT BOTTICELLI BT A1250 in Muscat and install it on residential garages across Oman.
Specifications
| Traction force | 120 kg (1250 N) |
| Door surface area | 16 m² |
| Motor voltage | 24V DC |
| Power consumption | 236W |
| Control unit | VENERE BT A DIS |
| Limit switch type | Encoder + mechanical stop |
| Opening speed | 190 mm/sec |
| Frequency of use | Very intensive |
| Protection rating | IP20 |
| Impact reaction | D-Track |
| Manual release | Steel cord/cable |
| Interconnectivity | Yes |
| Actuator weight | 5 kg |
| Environmental conditions | −20°C to +60°C |
| Country of origin | Italy |
Common questions
What speed does the door open at?
One BFT-affiliated listing for this exact product code gives a noticeably slower figure than the opening speed stated here. We could not confirm which is correct against the physical unit. Treat the figure on this page as unconfirmed until checked against the nameplate.
Why does the release use a steel cord instead of a key?
A garage door opener disengages from inside the garage rather than from outside like a gate motor. Pulling the cord releases the mechanism so the door can be lifted by hand during a power cut.
What does the display on the VENERE BT A DIS actually do?
It shows setup and diagnostic information on the control unit itself. This model also has a built-in four-channel receiver. A simpler BFT control unit exists without the display, set up with dip switches instead.
Can this connect into a wider access system later?
Yes. The control unit supports BFT’s interconnectivity protocol. It can link with other BFT devices on the same site down the line.
Part of our Garage Door Openers range — see the full BFT range we stock in Oman.
Reviews
There are no reviews yet.